We use cookies to ensure our website operates correctly and to monitor visits to our site. This helps us to improve the way our website works, ensuring that users easily find what they are looking for. To allow us to keep doing this, click 'Accept All Cookies'. Alternatively, you can personalise your cookie settings.

Accept All Cookies Personalise settings

High Speed Telemetry Module (MSTM)

The Multi-Unit Control Modem is a 400 to 450 MHz UHF frequency wireless modem, which is optimized for long distance communications. It offers high speed transmit to receive switching times, low latency, and has a full serial port and separate diagnostic port for real time diagnostics without interrupting data communications. The modem is a half-duplex modem used for multi-unit control of multiple vehicles on a single frequency or can be used as a high speed modem operating in a Simplex mode with a 50 Hz Update rate.

The modem typically operates in a half duplex modem for vehicle telemetry between the vehicle and the control station. However, it typically operates in a simplex mode for the High Speed Telemetry Module (HSTM) in which the vehicle TX has a 50 Hz update rate between the vehicle and the receive module. The modem is designed to be a frequency hopping modem, commands to the modem are sent through either the Advanced Vehicle Processor (AVP) on the vehicle or through the Universal Target Control Station (UTSC™) in which power and frequency is set. Therefore programming is not required for use in the vehicle or at the control station. Pre-programming of the modem is necessary for the use of the HSTM since there are no commands sent to inform the modem to change frequency or power output. If powered down, the modem remembers the last programmed frequency and power output setting.

The modem comes equipped with 3 Received Signal Strength Indication (RSSI) LED for visual reference as well as an analog 0-5V RSSI output.

Signal strength is calculated based on the last four valid receive packets with the correct Cycle Redundancy Check (CRC), and represented by RSSI 1, 2, and 3. When calculating the RSSI, the master takes into account all the packets received from the slaves and repeaters. Repeaters and slaves only transmit back to the master when they have information to send. Therefore, if no data is coming back to the master then RSSI will never get updated at the master, and the LED’s will be off.

Key Features

Wide input voltage range between 8 to 34 VDC

Adjustable transmit power (250 mW – 1 W)

Wide temperature specifications (-40°C - +85°C)

RSSI LED Indication – RSSI output voltage indication